Barrier Reef Pools · Mid-size model
Outback Dundee Fiberglass Pool
A 30 x 14 shell offered plain or with a full lounging ledge along one side.
Outback Dundee sizes and specifications
Manufacturer-published figures for every Outback Dundee build. Depths are measured inside the shell; finished coping and deck heights are set during installation.
| Build | Length | Width | Shallow | Deep | Lounger | Gallons |
|---|---|---|---|---|---|---|
| Outback Dundee | 30' | 14' | 3'8" | 5'10" | — | 12,400 |
| Outback Dundee Lounger | 30' | 14' | 3'8" | 5'10" | 8'6" x 4'6" | 12,200 |
Source: Barrier Reef Pools USA Outback Dundee page. Specifications can change between model years — we confirm current figures before order.
Who this model suits
Buyers deciding between maximum water and maximum lounging on the same footprint.
Included on every install
- Perimeter safety ledge moulded into the shell
- Smooth, non-porous gelcoat finish (low chemical demand)
- Lifetime structural shell warranty from Barrier Reef
- Utah permitting, excavation, plumbing and startup handled by our crew
Installing the Outback Dundee in Utah
A 30'–30' long · 14' wide shell needs open access for an excavator and a crane or boom truck on set day. On tight St. George infill lots and sloped Utah County foothill lots that access route — not the shell itself — is usually what decides the model. We check it before quoting.
Once permits are issued, most Barrier Reef installs go from dig to swimming in two to four weeks. Utah County builds also get freeze-thaw-appropriate plumbing runs so the pool can be winterized properly each fall; Southern Utah builds are set up for a far longer season and higher evaporation.