Barrier Reef Pools · Mid-size model
Grande Fiberglass Pool
Bench seating at both the shallow and deep ends, in 23 and 29 foot lengths.
Grande sizes and specifications
Manufacturer-published figures for every Grande build. Depths are measured inside the shell; finished coping and deck heights are set during installation.
| Build | Length | Width | Shallow | Deep | Lounger | Gallons |
|---|---|---|---|---|---|---|
| Grande 29 | 29' | 13' 9" | 3'5" | 6'5" | — | 12,200 |
| Grande 23 | 23' | 11' 3" | 3'5.5" | 5'10.5" | — | 7,400 |
Source: Barrier Reef Pools USA Grande page. Specifications can change between model years — we confirm current figures before order.
Who this model suits
Entertaining — most of the pool is seating rather than swim space.
Included on every install
- Perimeter safety ledge moulded into the shell
- Smooth, non-porous gelcoat finish (low chemical demand)
- Lifetime structural shell warranty from Barrier Reef
- Utah permitting, excavation, plumbing and startup handled by our crew
Installing the Grande in Utah
A 23'–29' long · 13' 9" wide shell needs open access for an excavator and a crane or boom truck on set day. On tight St. George infill lots and sloped Utah County foothill lots that access route — not the shell itself — is usually what decides the model. We check it before quoting.
Once permits are issued, most Barrier Reef installs go from dig to swimming in two to four weeks. Utah County builds also get freeze-thaw-appropriate plumbing runs so the pool can be winterized properly each fall; Southern Utah builds are set up for a far longer season and higher evaporation.