Barrier Reef Pools · Large model
Sydney Harbour Fiberglass Pool
A wide 16-foot body in 35 and 40 foot lengths — one of the roomiest shells Barrier Reef builds.
Sydney Harbour sizes and specifications
Manufacturer-published figures for every Sydney Harbour build. Depths are measured inside the shell; finished coping and deck heights are set during installation.
| Build | Length | Width | Shallow | Deep | Lounger | Gallons |
|---|---|---|---|---|---|---|
| Sydney Harbour 40 | 39'10 ½" | 16' | 3'6" | 6'6" | 9'.5" x 5'7" & 11'11" x 5'7" | 17,500 |
| Sydney Harbour 35 | 35' | 16' | 3'6" | 6'1" | 9'.5" x 5'7" & 8'8.75" x 5'7" | 13,987 |
Source: Barrier Reef Pools USA Sydney Harbour page. Specifications can change between model years — we confirm current figures before order.
Who this model suits
Big Utah County and Washington Fields lots where a standard 15-foot width looks undersized.
Included on every install
- Perimeter safety ledge moulded into the shell
- Smooth, non-porous gelcoat finish (low chemical demand)
- Lifetime structural shell warranty from Barrier Reef
- Utah permitting, excavation, plumbing and startup handled by our crew
Installing the Sydney Harbour in Utah
A 35'–39'10 ½" long · 16' wide shell needs open access for an excavator and a crane or boom truck on set day. On tight St. George infill lots and sloped Utah County foothill lots that access route — not the shell itself — is usually what decides the model. We check it before quoting.
Once permits are issued, most Barrier Reef installs go from dig to swimming in two to four weeks. Utah County builds also get freeze-thaw-appropriate plumbing runs so the pool can be winterized properly each fall; Southern Utah builds are set up for a far longer season and higher evaporation.